Fridge repairs in Table View
A fridge that is merely warm is not always a fridge that has lost gas. Thermostats, door seals, defrost systems, blocked vents and condenser fans all fail in ways that look similar from the outside.
We test before we replace. That means checking the compressor and start components, the condenser fan, the evaporator fan, the defrost circuit and the door seals, then confirming pressures and temperatures where the system allows.
Table View kitchens are often small, so a fridge is pushed into a tight gap or a hot garage. Restricted airflow around the condenser makes the unit work harder, and in summer that is enough to push a tired compressor over the edge.
What the work includes
- Temperature and pressure testing
- Compressor, relay and capacitor testing
- Thermostat and sensor replacement
- Defrost system and evaporator fan repairs
- Door seal and hinge adjustment
- Leak detection and regas where the system permits
- Honest advice when replacement costs less than repair
What you may be noticing
- The fridge runs constantly but the food is not properly cold
- Ice builds up inside the freezer compartment or on the back wall
- Water pools under the drawers or in the base
- A clicking sound every few minutes from the back
- The motor is hot to the touch and the sides feel warm all the time
- Condensation or frost on the door frame
Coastal note
What the coast changes for this job
Salt air does not get inside a sealed fridge, but it does attack condenser coils and painted panels in garages and outbuildings. Keeping the condenser clean and the unit off a damp floor makes a measurable difference to how long it lasts.
Questions
Fridge repairs FAQs
If your question is not here, send it on WhatsApp with a photo of the unit.
All general FAQsTable View · Blaauwberg coast
Need fridge repairs in Table View?
Send the suburb, the service and a photo or two. We will come back with the soonest slot and a realistic next step.