Skip to content

Heat pump installation and repairs in Table View

A heat pump moves heat instead of making it. That is why it uses so much less electricity than an element, and why the installation details matter so much to how well it performs.

We install and repair domestic heat pumps for hot water and reverse-cycle systems for heating. In Table View the load is often cooling in February and heating in July, so a reverse-cycle unit can earn its keep in both seasons.

Correct sizing, a well-positioned outdoor unit, insulated pipework and a geyser or cylinder that suits the heat pump are what separate a good installation from a noisy one that ices up in winter.

What the work includes

  • Heat pump and reverse-cycle system installation
  • Cylinder and geyser integration for hot water heat pumps
  • Defrost and low-ambient fault diagnosis
  • Compressor, fan and control repairs
  • Refrigerant leak detection
  • Noise and vibration correction

Signs of a heat pump problem

  • Hot water runs out faster than it used to
  • The unit ices up and stays iced for hours
  • The outdoor fan runs but the air is not colder or warmer than ambient
  • Frequent tripping or a controller showing a fault code
  • Rumbling, vibration or a noise that carries into the house
  • Electricity use climbing without a change in hot water demand

Coastal note

What the coast changes for this job

Heat pumps run year-round, including damp winter mornings when the outdoor coil is wettest. That combination of moisture and salt makes coil condition and casing protection important. A yearly clean and a look at the drain path prevents most winter icing complaints.

Questions

Heat pump installation and repairs FAQs

If your question is not here, send it on WhatsApp with a photo of the unit.

All general FAQs

Table View · Blaauwberg coast

Need heat pump installation and repairs in Table View?

Send the suburb, the service and a photo or two. We will come back with the soonest slot and a realistic next step.