Salt air and your outdoor unit: a prevention routine
5 min read · Table View, Cape Town
Outdoor units in Table View live in a harsher environment than the same equipment installed inland. Salt mist is carried on the wind, settles on the coil and casing, and holds moisture against bare aluminium and steel. The result is not a single dramatic failure but a slow loss of performance followed by corrosion you cannot undo.
What salt mist does to a condenser
A condenser works by rejecting heat through aluminium fins bonded to copper tubes. Anything coating those fins insulates them. Salt, sand and lint form a layer that reduces heat transfer, so the compressor runs longer and hotter for the same result.
Salt also attacks the fin material itself. Once the fins start to powder or separate from the tubes, cleaning restores less and less performance. That is why the useful question is not whether the coil is dirty but whether the metal is still intact.
A routine that actually helps
For a unit within a few hundred metres of the coast, plan on cleaning the outdoor coil at least twice a year, and more often if the unit sits low, faces the prevailing wind, or is near a building exhaust.
- Switch the unit off at the isolator before touching anything.
- Rinse the coil from the inside out with low-pressure water, not a high-pressure jet that bends the fins.
- Use a coil cleaner suited to aluminium and rinse it off properly; leaving chemical residue attracts more dirt.
- Check the fan blade for salt build-up and the motor shaft for play.
- Look at the bracket, screws and casing for rust blooms, which are usually the first sign of a mounting problem.
- Keep the area around the unit clear of stored items, plants and sand build-up.
Placement decisions that matter more than cleaning
A unit mounted at ground level behind a wall collects sand and spray. A unit raised on brackets with clear airflow and a serviceable gap will last longer with less effort. Where a replacement is due, choose a position that is easy to reach, away from sprinkler spray and not directly in the path of wind-driven salt.
Where the manufacturer offers a corrosion-protected coil or a coated casing for coastal use, it is worth pricing against the standard version. It is not a permanent answer, but it changes the timeline.
When corrosion has gone too far
If a coil is leaking refrigerant, cleaning will not fix it. Signs include repeated gas top-ups, oily residue around the coil, ice forming in one area, and a unit that cannot hold pressure. At that point the honest options are a coil or outdoor unit replacement, or a new system if the indoor section is also aged.
We quote both the repair and the replacement rather than pushing one. On coastal installations, the replacement often wins on cost over a few seasons.