Heat pumps in a Cape winter: icing, defrost and efficiency
5 min read · Table View, Cape Town
A heat pump extracts heat from outside air. When that air is cold and damp, the outdoor coil can drop below freezing and frost forms on it. The unit is designed to deal with that by reversing briefly to melt the frost. Problems start when the frost does not clear.
Normal icing versus a fault
During a defrost cycle you may see steam, hear a whoosh or a change in fan noise, and water running from the base. That is expected. It becomes a fault when ice stays on the coil for hours, when the unit never recovers its normal sound, or when the outdoor fan is jammed by ice.
Damp winter mornings in Table View are exactly the conditions that trigger frequent defrost cycles. A unit that handles them well will still be efficient; one with a sensor or airflow problem will spend most of its time defrosting and very little time heating.
Common causes of persistent ice
Most persistent icing comes down to four things: a faulty defrost sensor, restricted airflow across the coil, low refrigerant charge, or a drain path that lets meltwater refreeze at the base.
- Blocked or bent coil fins, or a unit boxed in by plants and stored goods.
- A defrost termination sensor reading incorrectly, so the cycle ends too early.
- Low charge from a slow leak, which drops coil temperature below design.
- A base tray or drain that cannot clear water, so it refreezes and builds up.
- A fan motor that is failing and no longer moves enough air.
What maintenance prevents
An annual clean and a set of operating readings before winter will catch most of these. Coil cleaning restores airflow, a drain check stops refreezing, and pressure readings show a slow leak before it becomes a mid-winter breakdown.
If your unit is more than a few years old and has never been serviced, book the check in autumn rather than waiting for the first cold snap.
Efficiency expectations
A heat pump should use noticeably less electricity than a resistive element for the same hot water or room heating. If consumption climbs without a change in use, icing, a dirty coil or a failing compressor are the usual suspects. We check the readings rather than guessing at the cause.